[ad_1]
Hole in drywall is something that can not be avoided. If you have kids or moving furniture it is very likely that the hole will appear. You don’t need to panic. Solution to the problem is simple and you don’t need to call a contractor, just follow these few simple steps and you can repair the hole like a professional.
1. Cleaning and cutting
Remove any debris or remaining paper from the hole. Tear away any loose wall material and brush away the dust. Then use a utility knife to cut the hole into a symmetrical square as shown on the picture below. Press firmly into the wall material and use a straightedge to follow a careful line. Remove the excess wall material. After cutting the hole measure it and cut a slightly smaller part of drywall or plywood and cut the plank or 2×4 which is 4 inches bigger than the hole. That plank or 2×4 will be used as an anchor board.
2. Mounting the anchor board and the patch
Put anchor board in the hole behind the drywall and be sure that the board is positioned 2 inches over the top and the bottom edge. Then drill two holes with the cordless drill through the drywall and the anchor board and secure it with drywall screws. After mounting the anchor board it is time to secure the patch, just put the patch in the hole and on to anchor board and drill two holes through the patch and the anchor board and secure it with drywall screws.
3. Apply wallboard tape and compound
Smoothly apply the wallboard tape around all four edges of the patch and then apply the wallboard compound with the putty knife and wait until the compound is completely dry. Then use a sanding sponge to smooth all the edges and to remove any dimples or ridges. Always use circular movements when sanding to avoid making holes and always check everything with your hand to make sure that is completely smooth.
4. Preparing and painting
Before painting the repaired surface always apply one coat of primer first and let the primer dry for at least an hour. Then you can apply the first coat of paint with the paint roller and let the paint to dry for about three hours and then apply the second coat of paint. After the second coat is dry the placing of the patch will become unobservable and the wall will be as good as new!
Now you can see that the hole in drywall is something that anyone can repair without calling the professionals.
Share this tip with your friends!
[ad_2]
Source link